Regarding the issue of resetting the laser cutting machine

Regarding the issue of resetting the laser cutting machine

With the development of technology in our country, the use of laser cutting is becoming increasingly popular. However, there are always many problems during the use of equipment. Today, we will talk about situations such as abnormal reset of laser cutting machines. Below, we will briefly analyze the reasons for abnormal reset of laser cutting machines.

Since the use of laser cutting machines, there have been many precautions. Laser cutting machines not only use the technology used in the process, but also require data correction to solve problems.

Leakage of laser cutting machine, incorrect initialization, data sent (corrected); Reverse the order (re input); Static interference (check if the ground wire is loose); Clean the misaligned and unclosed edges, and check if the software parameter settings are correct (reset); Computer system error (reinstalling the system and software); Check if the tension of the left and right belts is consistent or if the rear belt is too loose (belt tightening); Check if the belt or synchronous wheel is slipping or jumping teeth (tighten the synchronous wheel or belt); Check if the crossbeam is parallel (readjust the left and right belts).

The reasons for abnormal reset of the laser cutting machine include the following aspects:

1. The X-axis and Y-axis of the laser cutting machine move in opposite directions and collide with the side end. This phenomenon requires checking if the motherboard parameters are incorrect and stopping the machine to check if there are any problems with the motherboard parameter settings.

2. The control panel of the laser cutting machine displays normally, but the X-axis and Y-axis do not move. You can try unplugging the sensor terminals on the motherboard to see if the machine is moving. In this case, you need to consider replacing the sensor.

3. The crossbeam reset is normal, but the X-axis of the laser cutting machine does not reset. It is possible that the motor wire or motor shaft is broken, and this phenomenon requires replacing the motor wire or small motor.

4. When resetting, the direction is correct, but when it reaches the vertex, the X-axis or Y-axis cannot stop (check the motherboard parameters first). If it is correct, check the motherboard or sensor and replace it to eliminate this phenomenon.